Programmed to Party

Today’s card shows how awesome gel transfer can look, and pairs some fun new and old Heffy Doodle products to make an adorable robot card!

Hi, everyone! I’m back today to share a fun card with you all! I tried using transfer gel to foil a stencil for this card, and I have to admit-I love the way it turned out!! Let’s get started! I started the card for today with the stenciling. I used transfer gel over the Love Circuit stencil. After applying a even layer and washing the stencil off, I let the gel dry for about an hour. That’s when I used my Minc to foil the pattern with some copper foil. I love the way this turned out, especially with this circuit image!!

Next, I did all of my stamping and die cutting. I die cut one of the Stitched Square dies, and die cut the stenciled piece down with one of the Stitched Circle dies. I wanted to make a smaller, square card so I picked sizes that worked for that. I also die cut four of the Party dies to be stacked together, and one of the banners from the Tag Along Die set.

I heat embossed a partial sentiment onto the banner after coloring it with one of my Copic markers so that it matched the robot I stamped from the Bots of Love stamp set! I love the cute robots in this set! To add some interest to my stitched square I stamped some of the gears from the set with VersaMark, and added some splatter to it and the stenciled piece.

To finish the card I put everything together with foam tape and glue, and my card was complete! Thank you so much for joining me today! I hope you enjoyed the card I made, and I will see you again soon with another one!